to see inside. Adaptation-24 This is useful to determine if the terrarium
is running correctly later. Also, you will be able to see if moisture that
has collected in the bottle needs to be emptied out of it.
Heat up the threads on the 3/8 inch bolt using a propane touch or
burner on a gas stove. A cigarette lighter will work, but it will take a
long time. Hold onto the bolt with the pliers. When the bolt is hot,
quickly and neatly poke two holes in each 2 liter coke bottle.
Adaptation-15 See the following diagram for details:
The bolt that is used is deliberately a little smaller than the hole that
needs to be generated. The hot bolt will melt the hole a little bit bigger
than it is when it pokes through the plastic bottle. You may need to
insert the bolt a second time into the hole and let it touch the sides to
expand the diameter of the hole. Some times little chunks of plastic
stick to the side of the hole. Use a sharp knife to clean up the edges
and insert a grommet. Check the fit of the vinyl tubing through the
grommet. It should be very snug and air tight, but it should not
collapse the inner diameter of the tubing very much.
Connect a piece of tubing from the humidifier to the first coke bottle.
Flute both ends of each piece of vinyl tubing. Connect the this coke
bottle to the next. Do this until you have all four coke bottles
connected. The picture shows 3 coke bottles because that is what is
normally required, but for now connect in all 4. Now connect the last
coke bottle to the terrarium. You will need to poke a hole in the side
and insert the tubing. The tubing should be blowing humid air into the
(22 of 29) [5/1/2002 6:54:17 PM]
How To Grow Magic Mushrooms The Magic Mushroom Growers Guide (page 2)
part of the terrarium that is above the drip shield. It should be setup as
follows:
Checking out the Ultra Sonic Humidifier
Setup:
Fill the humidifier with water and position the various stages of the
coke bottles between the humidifier and terrarium. At no place should
the vinyl tubing have a low spot for condensation to form and plug up
the line. Condensation will form in the lines but it should run to the
end and drip harmlessly out of the line.
Set the humidity level at the minimum setting. This is still more than
you should need. Adaptation-19 After you give it time to stabilize, you
should see that each stage of the coke bottles has less fog in it than the
preceding stage. Usually, 3 bottles is the right amount, but depending
on your humidifier and ambient humidity, it could be more or less.
You want the last coke bottle to just have the slightest hint of fog in it.
Add or delete stages as necessary.
The humidity in the terrarium should stabilize at about 90%. The ideal
amount of humidity is as much as you can get without moisture
forming on the rice cakes. Keep in mind that most humidity meters
you get at department stores are not very accurate.
(23 of 29) 5/1/2002 6:54:17 PM]
How To
to see inside. Adaptation-24 This is useful to determine if the terrarium
is running correctly later. Also, you will be able to see if moisture that
has collected in the bottle needs to be emptied out of it.
Heat up the threads on the 3/8 inch bolt using a propane touch or
burner on a gas stove. A cigarette lighter will work, but it will take a
long time. Hold onto the bolt with the pliers. When the bolt is hot,
quickly and neatly poke two holes in each 2 liter coke bottle.
Adaptation-15 See the following diagram for details:
The bolt that is used is deliberately a little smaller than the hole that
needs to be generated. The hot bolt will melt the hole a little bit bigger
than it is when it pokes through the plastic bottle. You may need to
insert the bolt a second time into the hole and let it touch the sides to
expand the diameter of the hole. Some times little chunks of plastic
stick to the side of the hole. Use a sharp knife to clean up the edges
and insert a grommet. Check the fit of the vinyl tubing through the
grommet. It should be very snug and air tight, but it should not
collapse the inner
paypal@sheesha
diameter of the tubing very much.
Connect a piece of tubing from the humidifier to the first coke bottle.
Flute both ends of each piece of vinyl tubing. Connect the this coke
bottle to the next. Do this until you have all four coke bottles
connected. The picture shows 3 coke bottles because that is what is
normally required, but for now connect in all 4. Now connect the last
coke bottle to the terrarium. You will need to poke a hole in the side
and insert the tubing. The tubing should be blowing humid air into the
(22 of 29) 5/1/2002 6:54:17 PM]
How To Grow Magic Mushrooms The Magic Mushroom Growers Guide (page 2)
part of the terrarium that is above the drip shield. It should be setup as
follows:
Checking out the Ultra Sonic Humidifier
Setup:
Fill the humidifier with water and position the various stages of the
coke bottles between the humidifier and terrarium. At no place should
the vinyl tubing have a low spot for condensation to form and plug up
the line. Condensation will form in the lines but it should run to the
end and drip harmlessly out of the line.
Set the humidity level at the minimum setting. This is still more than
you should need. Adaptation-19 After you give it time to stabilize, you
should see that each stage of the coke bottles has less fog in it than the
preceding stage. Usually, 3 bottles is the right amount, but depending
on your humidifier and ambient humidity, it could be more or less.
You want the last coke bottle to just have the slightest hint of fog in it.
Add or delete stages as necessary.
The humidity in the terrarium should stabilize at about 90%. The ideal
amount of humidity is as much as you can get without moisture
forming on the rice cakes. Keep in mind that most humidity meters
you get at department stores are not very accurate.
(23 of 29) 5/1/2002 6:54:17 PM]
How To
to see inside. Adaptation-24 This is useful to determine if the terrarium
is running correctly later. Also, you will be able to see if moisture that
has collected in the bottle needs to be emptied out of it.
Heat up the threads on the 3/8 inch bolt using a propane touch or
burner on a gas stove. A cigarette lighter will work, but it Shop Head will take a
long time. Hold onto the bolt with the pliers. When the bolt is hot,
quickly and neatly poke two holes in each 2 liter coke bottle.
Adaptation-15 See the following diagram for details:
The bolt that is used is deliberately a little smaller than the hole that
needs to be generated. The hot bolt will melt the hole a little bit bigger
than it is when it pokes through the plastic bottle. You may need to
insert the bolt a second time into the hole and let it touch the sides to
expand the diameter of the hole. Some times little chunks of plastic
stick to the side of the hole. Use a sharp knife to clean up the edges
and insert a grommet. Check the fit of the vinyl tubing through the
grommet. It should be very snug and air tight, but it should not
collapse the inner diameter of the tubing very much.
Connect a piece of tubing from the humidifier to the first coke bottle.
Flute both ends of each piece of vinyl tubing. Connect the this coke
bottle to the next. Do this until you have all four coke bottles
connected. The picture shows 3 coke bottles because that is what is
normally required, but for now connect in all 4. Now connect the last
coke bottle to the terrarium. You will need to poke a hole in the side
and insert the tubing. The tubing should be blowing humid air into the
(22 of 29) 5/1/2002 6:54:17 PM
How To Grow Magic Mushrooms The Magic Mushroom Growers Guide (page 2)
part of the terrarium that is above the drip shield. It should be setup as
follows:
Checking out the Ultra Sonic Humidifier
Setup:
Fill the humidifier with water and position the various stages of the
coke bottles between the humidifier and terrarium. At no place should
the vinyl tubing have a low spot for condensation to form and plug up
the line. Condensation will form in the lines but it should run to the
end and drip harmlessly out of the line.
Set the humidity level at the minimum setting. This is still more than
you should need. Adaptation-19 After you give it time to stabilize, you
should see that each stage of the coke bottles has less fog in it than the
preceding stage. Usually, 3 bottles is the right amount, but depending
on your humidifier and ambient humidity, it could be more or less.
You want the last coke bottle to just have the slightest hint of fog in it.
Add or delete stages as necessary.
The humidity in the terrarium should stabilize at about 90%. The ideal
amount of humidity is as much as you can get without moisture
forming on the rice cakes. Keep in mind that most humidity meters
you get at department stores are not very accurate.
(23 of 29) 5/1/2002 6:54:17 PM
How To
to see inside. Adaptation-24 This is useful to determine if the terrarium
is running correctly later. Also, you will be able to see if moisture that
has collected in the bottle needs to be emptied out of it.
Heat up the threads on the 3/8 inch bolt using a propane touch or
burner on a gas stove. A cigarette lighter will work, but it will take a
long time. Hold onto the bolt with the pliers. When the bolt is hot,
quickly and neatly poke two holes in each 2 liter coke bottle.
Adaptation-15 See the following diagram for details:
The bolt that is used is deliberately a little smaller than the hole that
needs to be generated. The hot bolt will melt the hole a little bit bigger
than it is when it pokes through the plastic bottle. You may need to
insert the bolt a second time into the hole and let it touch the sides to
expand the diameter of the hole. Some times little chunks of plastic
stick to the side of the hole. Use a sharp knife to clean up the edges
and insert a grommet. Check the fit of the vinyl tubing through the
grommet. It should be very snug and air tight, but it should not
collapse the inner diameter of the tubing very much.
Connect a piece of tubing from the humidifier to the first coke bottle.
Flute both ends of each piece of vinyl tubing. Connect the this coke
bottle to the next. Do this until you have all four coke bottles
connected. The picture shows 3 coke bottles because that is what is
normally required, but for now connect in all 4. Now connect the last
coke bottle to the terrarium. You will need to poke a hole in the side
and insert the tubing. The tubing should be blowing humid air into the
(22 of 29) 5/1/2002 6:54:17 PM
How To Grow Magic Mushrooms The Magic Mushroom Growers Guide (page 2)
part of the terrarium that is above the drip shield. It should be setup as
follows:
Checking out the Ultra Sonic Humidifier
Setup:
Fill the humidifier with water and position the various stages of the
coke bottles between the humidifier and terrarium. At no place should
the vinyl tubing have a low spot for condensation to form and plug up
the line. Condensation will form in the lines but it should run to the
end and drip harmlessly out of the line.
Set the humidity level at the minimum setting. This is still more than
you should need. Adaptation-19 After you give it time to stabilize, you
should see that each stage of the coke bottles has less fog in it than the
preceding stage. Usually, 3 bottles is the right amount, but depending
on your humidifier and ambient humidity, it could be more or less.
You want the last coke bottle to just have the slightest hint of fog in it.
Add or delete stages as necessary.
The humidity in the terrarium should stabilize at about 90%. The ideal
amount of humidity is as much as you can get without moisture
forming on the rice cakes. Keep in mind that most humidity meters
you get at department stores are not very accurate.
(23 of 29) 5/1/2002 6:54:17 PM
How To " />