Available Water Bongs For Sale in
headshop payPAL
headshops amsterdam stacker
PHX bongs
BONG shop payPAL
Headshop
Headshop
head shops
haschpfeifen
haschpfeifen
Zongs/Bongs
Sale Bong Sale Sale
marijuana seed factories in amsterdam
zongs/bongs

the bottom of the cooler. Then, use a pair of pliers to
bend a 1/2 inch ridge all the way around the piece of wire mesh. The
piece of mesh will be held up by the bent ridge. Often times, when
mushrooms are growing, space above them is at a premium. Try not to
raise the wire mesh more than a 1/2 inch above the bottom of the
cooler. Doing that simply wastes valuable space.
Next, if you are going to use the hand sprayer method of adding
humidity, a drip shield needs to be installed. If you are using a fish
tank bubblier or an ultra sonic humidifier, it is optional but still a good
idea. As moisture condenses inside the terrarium, this protects the rice
cakes from being 'rained' upon. Any moisture that forms on the lid of
the cooler can drip and will be stopped by the drip shield from hitting
the rice cakes. Any moisture that forms on the bottom side of the drip
shield will form beads and run down to the side of the terrarium where
it can drip harmlessly. If you use a piece of plexi-glass that is textured
on one side, put the textured side pointing up. You want a smooth
surface on the bottom side of the drip shield so that moisture can easily
run down to the side of the terrarium.
The drip shield is held up by several bolts sticking through the side of
the cooler. Depending on what size canning jars you use and the height
of your wire mesh, you will need to figure out where to put them. You
want the drip shield to be at as steep of angle as possible to make water
(13 of 29) 5/1/2002 6:54:17 PM]
How To Grow Magic Mushrooms The Magic Mushroom Growers Guide (page 2)
run down it easily, but you want it high enough that your mushrooms
have room to grow without touching the drip shield. The drip shield
needs to fit well. You need a small gap on the edges to let air circulate,
but keep it small. About 1/4 inch is good. In other words, the drip
shield should fit pretty well to the inside of the cooler, but it is not
supposed to be air tight. Also remember when shaping the drip shield
that you can not go to the very top of the cooler because the lid will
recess into the cooler a little ways.
If you are using a Styrofoam cooler, you should use washers on the
bolts on both the inside and outside of the cooler. This will allow you
to tighten the nuts on the bolts snugly to keep the bolts from tearing up
the cooler as you move the drip shield during normal maintenance.
Next, the top of the cooler needs to be modified to allow light to enter
the terrarium. Psilocybe Cubensis is a phototropic mushroom. It needs
light to initiate pinning and to tell the mushrooms which way is up.
You should have some plexi-glass left over from the drip shield that
can be used for this purpose. Cut a hole in the top of cooler. Cut a
piece of plexi-glass a little bit bigger than the hole in the cooler lid.
Run a bead of silicon glue all the way around the hole in the cooler
top. Position the plexi-glass over the hole and let the glue setup.
zongs/bongs -
bongs